Seiko TM-L60 Instalační manuál stáhnout pdf (Strana 37)

Rev.B APD Installation and Setup 2-19

Advanced Printer Driver Installation Manual

Adding or Removing Printers

To add a printer to the computer or remove a printer that is no longer necessary from the

computer, follow the procedures below.

Adding a printer

To add a printer, install the printer driver and configure the port by following "APD Installation

and Printer Driver Setup" on page 2-5 .

Note:

You cannot add the printer driver directly from the

Printers and Faxes screen.

When connecting a USB printer, you cannot add the printer driver using the Windows plug and

play feature.

Removing a printer

To remove the driver of a printer that is no longer necessary from the computer, uninstall the

printer driver by following "Uninstalling a printer driver" on page 2-27 .

Replacing a printer

When replacing a printer for another of the same model and same interface due to repair, for

example, note the following points.

Make sure the DIP switches on the new printer are configured with the same settings as those on

the replaced printer, regardless of the interface.

❏ Serial If the DIP switch settings for serial communication are the same, no

configuration is necessary following the replacement.

❏ Parallel No configuration is necessary following the replacement.

❏ USB If the printer's interface card changes because the printer is changed, the

APD recognizes it as a new printer connection and therefore generates a

new Epson Port (USB). For this reason, you must configure the newly

generated Epson Port with the same settings as those of the Epson Port to

which the printer driver was assigned.

❏ Ethernet No configuration is necessary on the printer driver if the same IP address

as for the replaced printer is used for the new one.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 61 62

Žádné komentáře

Seiko TM-L60 Instalační manuál Strana 37