Seiko TM-L60 Instalační manuál stáhnout pdf (Strana 31)

Rev.B APD Installation and Setup 2-13

Advanced Printer Driver Installation Manual

USB connection

When using USB connection, reboot the computer after installing all the printer drivers to be

used simultaneously. Then, connect the printer and turn on the power.

Note:

To add a printer driver afterwards, install the printer driver after connecting all the TM printers

using USB connection and turning on their respective power. Otherwise, an Epson Port

reassignment may occur as the driver for disconnected or powered off printers are recognized as

replaced.

If you have connected the printer before installing the printer driver, perform a printer driver

recovery. For details, see "Recovering the Printer Driver - For USB Interface Printer" on page 2-26 .

Restrictions

• Connectable printers and USB devices: USB cable length of up to 5 m, up to 5 cascaded

hubs. Use USB cables and USB hubs compliant with USB 2.0 standard.

• The maximum number of printers that can be connected simultaneously is 8.

• When turning the power off and then on, wait at least 5 seconds between power off and

power on.

For details, see the C:\EPSON Advanced Printer Driver\Setup_TM\Usb\readme_e.txt

generated after the APD installation.

Ethernet (10/100 Base-T) connection

When using Ethernet connection, check the IP address setting. To configure the IP address, use

the Epson TM Netwingconfig Utility.

For details, see the "UB-R02 Technical Reference Guide."

Wireless LAN (IEEE 802.11.b) connection

When using wireless LAN connection, check the IP address setting. To configure the IP address,

use the Epson TM Netwingconfig Utility.

Also check the security measures and location sufficiently.

For details, see the "UB-R02 Technical Reference Guide."

Parallel (LPT) connection

When the printer is connected, the "New Hardware Detected. EPSON TM-P2.01" screen appears

then the "Found New Hardware Wizard"screen. In this case, perform the following steps.

1. Click the [Next] button to search for the driver.

2. Next, click the [Finish] button without the driver been found and close the "Found New

Hardware Wizard"screen.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 61 62

Žádné komentáře

Seiko TM-L60 Instalační manuál Strana 31