Seiko TM-L60 Specifikace stáhnout pdf (Strana 69)

1-62 Command Descriptions Rev. A

GS <

[Name] Initialize printer mechanism

[Format] ASCII GS <

Hex 1D 3C

Decimal 29 60

GS < feeds label paper to the printing start position. This command is only effective when thermal

label is selected with the paper selection DIP switch, and does not initialize the values set by other

commands.

GS A m n

[Name] Adjust print starting position

[Format] ASCII GS A mn

Hex 1D 41 mn

Decimal 29 65 mn

[Range] 0 ≤ m ≤ 255 (Only the least significant bit of m is enabled.)

0 ≤ n ≤ 255

GS A m n adjusts the label print starting position in a selected direction, and by a specified amount

from the default position. This command is effective only when Thermal Label is selected with the

paper selection DIP switch. This command will be ignored unless it is received just after feeding a

label to the print starting position, using the FF, GS FF, or GS < commands, or by pressing the PAPER

FEED button, or at the time of power-on. The default setting is m=0, n=0. When executing the

commands, the paper is fed to adjust the print starting position of the current label, as follows.

m specifies the adjusting direction. When the LSB of m = 0, the label position is adjusted in the normal

direction. When the LSB of m = 1, the label position is adjusted in the reverse direction.

n specifies the adjustment amount. The adjustment amount formula is [n × (vertical motion unit)]

inches. The vertical motion units use the vertical value set by the GS P. The default setting of the

vertical motion unit is 1/360 inch.

Program Example

PRINT #1, CHR$(&H1D);"<";

Program Example

PRINT #1, CHR$(&H1D);"A";CHR$(0);CHR$(18);

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 97 98

Žádné komentáře

Seiko TM-L60 Specifikace Strana 69