Seiko LP-1020L Uživatelská příručka stáhnout pdf (Strana 66)

2-24

When the waste bottle is nearly full with waste toner, the Waste toner

lamp will flash. Although plots can continue to be produced for a little

while longer, replace the waste bottle soon.

When the waste bottle becomes full with waste toner, the Waste toner

lamp will go out. The Error lamp will turn on and plotting will not be

possible. The following message appears on the LCD.

If the Waste toner lamp starts flashing or the message appears on the

control panel, replace the waste bottle in accordance with the procedures

outlined below.

◆ A “Waste bottle replacement” label is affixed to the side of the

waste toner bottle. Refer to this when replacing the waste

bottle.

◆ Even after the Waste toner lamp starts flashing, you should be

able to produce about 120 m of plots.

Warning

Replacing the waste toner bottle

Precautions during replacement

Do not throw waste bottles containing waste toner into

fire.

Doing so may cause an accident and fire.

Dispose of waste bottles as non-burnable garbage.

CHANGE

WA S T E BO T T L E

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 289 290

Žádné komentáře

Seiko LP-1020L Uživatelská příručka Strana 66