Seiko TM-L60 Uživatelský manuál stáhnout pdf (Strana 17)

5 Serial Connection

When the TM printer is connected to the host PC with a serial interface, the usable serial cross

cable is as follows:

6 Self-test Mode

In self-test mode, the following items are checked and printed out:

•Control software version

• DIP switch settings

And others.

Use the following procedure to start a self-test.

1. To start the selftest, hold down the FEED button (*1)(*2) and turn on the printer with the roll

paper cover closed.

Note:

(*1) With the TM-J2000/TM-J2100, hold down the PAPER FEED button instead of the FEED button.

(*2) With the TM-L90, keep holding down the FEED button until the ERROR LED comes on.

2. After printing the current printer status, the printer prints the message to show the standby

state; then the paper out LED blinks. The printer is now in the self-test wait mode.

3. To start a test print, press the FEED button when the printer is in the self-test wait mode.

4. Make sure that the following message is printed.

*** completed ***

1 2 ... 12 13 14 15 16 17 18

Žádné komentáře

Seiko TM-L60 Uživatelský manuál Strana 17