Seiko TM-L60 Specifikace stáhnout pdf (Strana 27)

Chapter 2 Installation and Setup

Connecting the TM Printer

BeforeconnectingtheTMprinter,settheHandshakingsettingoftheprintertoReceivebuffer

full.

ConnecttheTMprinter.ForinformationonhowtoconnecttheTMprinterandconfigurethe

DIPSW,seetheUsersManualsuppliedwiththeTMprinterortheTechnicalReferenceGuide.

Parallel (LPT) connection

Whentheprinterisconnected,theNewHardwareDetected.EPSONTM‐P2.01screenappears

thentheFoundNewHardwareWizardscreen.Inthiscase,performthefollowingsteps.

Click the [Next] button to search for the driver.

The driver is found and installed.

Serial (COM) connection

Whenusingtheserialconnection,makesuretheprintersettingsmatchtheprinterdriverport

settings(BaudRate/DataBits/Parity/StopBits/FlowControl).

SettheHandshakingoperation(BUSYcondition)fortheTMprinterto[Receivebufferfullonly].

Settingmethodsandapplicablemodelsareshownbelow.

Ethernet (10/100 Base-T) connection

WhenusingEthernetconnection,checktheIPaddresssetting.

FortheproceduretoconfigureanIPaddressfortheTMprinter,see

ConfiguringanIPaddress

fortheTMprinteronpage67

 The maximum number of printers that can be simultaneously connected to multiple

computers is 8.

 Turn off the power of the TM printer and wait for more than 5 seconds before turning on

the power.

Setting method Applicable models

Set by user via TM printer DIP switches Models other than the following

User setting is not required. The printer driver

sets memory switches automatically.

TM-J7000/7100, TM-J7500/7600, TM-L90, TM-

L90Peeler, TM-T90, TM-T20, TM-U120, TM-U120II,

EU-T300, EU-T400, EU-T500, BA-T500, BA-T500II

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 83 84

Žádné komentáře

Seiko TM-L60 Specifikace Strana 27